Good source for MS Sheet ready cut to size in the UK - Printable Version +- RomanArmyTalk (https://www.romanarmytalk.com/rat) +-- Forum: Reenactment (https://www.romanarmytalk.com/rat/forumdisplay.php?fid=5) +--- Forum: Roman Re-Enactment & Reconstruction (https://www.romanarmytalk.com/rat/forumdisplay.php?fid=26) +--- Thread: Good source for MS Sheet ready cut to size in the UK (/showthread.php?tid=27329) |
Good source for MS Sheet ready cut to size in the UK - Fabricius Carbo - 06-20-2016 Not sure if this is the right place for this but I found a good source for Mild Steel Sheet in the UK. I used thrm to source the steel for my Segmentata. Sheet sizes from 500 x 500 mm up to 500 x 1250 They offer a cutting service with the first 10 cuts per sheet for free, straight cuts. They can also do mitre cuts, profiling and laser cutting of shapes but at extra cost https://www.themetalstore.co.uk I don't have any connection with them other than as a customer. RE: Good source for MS Sheet ready cut to size in the UK - brennivs - tony drake - 06-20-2016 Fabricivs there is also this store http://metalsupermarkets.co.uk/gateshead/ This one is near me but nation wide they also cut the plates for a lorica I made if I remember right £ 35 for a 8 x 4 ft sheet but that was a few years ago I liked this seller because you can walk in and see what they have,to me a sweet shop Regards Brennivs RE: Good source for MS Sheet ready cut to size in the UK - Fabricius Carbo - 06-20-2016 Gateshead is good, I am on Teesside and do a lot of work in Team Valley. How do they charge for cutting? RE: Good source for MS Sheet ready cut to size in the UK - brennivs - tony drake - 06-20-2016 If I am right they didn't charge but I just had the girdle plates/shoulder ect and thechest plates as one stripes I have a bench cutter. I presume you are going to make a Seggy ? Well you are in the right place Regards Brennivs |