Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Turned Aspis Project in Progress
#55
Is there anyone carving for tourists near you? Perhaps you can hook up with some artist's grandfather or uncle? I thought of always holding the rim as the base line and arching the cuts with 20 mm on either side of the finshed lines. Then you could plane, rasp, file and sand your way to the end shape. In any case, NO VOIDS in the gluing - the piece will fail at the bad joint. Good luck.

If you find someone, offer to learn from them. Even though I only swept up shavings and was an extre set of hands, Ed was pleased to share his knowledge (and stories, too).
Cheryl Boeckmann
Reply


Messages In This Thread
Re: Turned Aspis Project in Progress - by Chris B - 05-27-2008, 08:45 PM
Re: Turned Aspis Project in Progress - by Kineas - 06-02-2008, 01:41 PM
Re: Turned Aspis Project in Progress - by Athena Areias - 06-02-2008, 11:02 PM
Re: Turned Aspis Project in Progress - by Kineas - 06-16-2008, 01:40 PM
turned aspis - by The Spinner - 06-17-2008, 12:21 PM
print - by The Spinner - 06-17-2008, 09:27 PM
Turned Aspis project - by Paullus Scipio - 06-18-2008, 01:58 AM
Re: Turned Aspis Project in Progress - by Magnus - 03-12-2009, 02:27 AM
RE: Turned Aspis Project in Progress - by Feinman - 08-14-2017, 11:37 AM

Forum Jump: