02-03-2009, 08:02 PM
There are cheaper grinders that would do the same job 
http://cgi.ebay.com/FREE-SHIPPING-North ... 7C294%3A50
This is an example, if you have never ground a blade it is best to try first with a cheap grinder then go for a good make, I rarely pay no more than $35-40 for one. As to cutting the blade out, eithier a hack saw blade or a cutting disc will do the job
![[Image: P4060004.jpg]](http://i162.photobucket.com/albums/t272/brennivs/P4060004.jpg)
The botttom one is 1mm thick and is ideal for cutting points and best part of the tang out with. Then you can do as Magnvs says to finish the cutting. If you do cut the tang with a hacksaw it could take about 40+ minutes to do so cutting the bulk of with a disc will save you
Regards Brennivs
http://cgi.ebay.com/FREE-SHIPPING-North ... 7C294%3A50
This is an example, if you have never ground a blade it is best to try first with a cheap grinder then go for a good make, I rarely pay no more than $35-40 for one. As to cutting the blade out, eithier a hack saw blade or a cutting disc will do the job
The botttom one is 1mm thick and is ideal for cutting points and best part of the tang out with. Then you can do as Magnvs says to finish the cutting. If you do cut the tang with a hacksaw it could take about 40+ minutes to do so cutting the bulk of with a disc will save you
Regards Brennivs
Woe Ye The Vanquished
Brennvs 390 BC
When you have all this why do you envy our mud huts
Caratacvs
Centvrio Princeps Brennivs COH I Dacorivm (Roma Antiqvia)
Brennvs 390 BC
When you have all this why do you envy our mud huts
Caratacvs
Centvrio Princeps Brennivs COH I Dacorivm (Roma Antiqvia)
