10-07-2011, 12:10 AM
If you put your buckle plate next to the apron straps that should just about be right, then another good way to prevent the belt apron pulling over is to take the straps right over the back of the belt and use the upper apron studs to hold them on.
That way they can be riveted just a small fraction below centre and it will look tidy, as far as belt thickness I would say no more than 3mm but better at around 2mm.
That way they can be riveted just a small fraction below centre and it will look tidy, as far as belt thickness I would say no more than 3mm but better at around 2mm.
Brian Stobbs