Posts: 204
Threads: 7
Joined: Jun 2007
Reputation:
0
Salve, all.
I did a search, but was unsuccessful, so forgive me if this topic has been covered before.
I'm interested in making large copper rivets, with perhaps a shank diameter of 1/4" to 1/2". A blacksmith I am working with has been helping me using modern methods (air hammer), but any insights or experiences in making rivets would be appreciated using hand tools.
Thanks in advance.
Dane Donato
Legio III Cyrenaica
Posts: 7,668
Threads: 117
Joined: Apr 2005
Reputation:
0
Get your blacksmith to show you how to make a nail header. A rivet is just a short nail with no point needed, after all. Once done, a hand hammer will do the same thing as a power hammer, it just takes longer, and uses muscle power instead of a machine.
M. Demetrius Abicio
(David Wills)
Saepe veritas est dura.
Posts: 2,012
Threads: 52
Joined: Sep 2006
Reputation:
14
I do hope these are not for shields, as a lot of data show nails with large domed carpenter tack like heads. The sharp ends were folded over and driven into the shield.
By the way, guys, Germanic shieldboss in Batavian context found with nice ROUND ring on which rivet was preened. :lol:
Posts: 204
Threads: 7
Joined: Jun 2007
Reputation:
0
David, thanks for the advice.
No, Robert, most certainly not. The rivets are for my latest catapulta, a 2" scorpio. I'll be riveting the steel plating to the spring frame, as well as the trigger mechanism to the end of the slider.
The machine weighs in at 17 pounds so far, and is about 5' long.
Dane Donato
Legio III Cyrenaica
Posts: 204
Threads: 7
Joined: Jun 2007
Reputation:
0
Oh, Robert, isn't that known as dead nails, when you drive the ends in? Dead as a doornail, so to speak
Dane Donato
Legio III Cyrenaica