07-22-2007, 01:17 PM
Tinning... I know there was a tutorial on that somewhere???
Isn't that basically fluxing and torching melting on?
Reason why I ask is I am using 16 gauge and it is somewhere between a hot rolled and cold rolled state as it has a darker tone to it. To remove it, it takes a serious amount of passes with an angle grinder/flapdisk to remove and reduces the thickness significantly. So tinning may just be the solution.
If so, what flux is used?
Isn't that basically fluxing and torching melting on?
Reason why I ask is I am using 16 gauge and it is somewhere between a hot rolled and cold rolled state as it has a darker tone to it. To remove it, it takes a serious amount of passes with an angle grinder/flapdisk to remove and reduces the thickness significantly. So tinning may just be the solution.
If so, what flux is used?
Q. ARTORIVS CORVINVS
aka: Phillip Vautour
"Rome is but a wilderness of tigers, and tigers must prey."
<a class="postlink" href="http://rubicon.dyndns.org/legioxxi">http://rubicon.dyndns.org/legioxxi
aka: Phillip Vautour
"Rome is but a wilderness of tigers, and tigers must prey."
<a class="postlink" href="http://rubicon.dyndns.org/legioxxi">http://rubicon.dyndns.org/legioxxi
