04-05-2007, 12:52 PM
Well, could only find some large round ones, so the plan is to grind them square with the dremel!
Not sure if the is enough room between the original 2 holes to make a third one, without weakening the wood? The holes as is need modification, being different sizes to accomodate the pin setup from the removeable ones, and as I don't have a bench with a vise, I am a little worried about making a botchjob if I were to try to drill another one...... :? roll:
Mind you, I could be less of a prima-donna, and go for it!! :lol: :lol:
But it would look good, I have seen Armillums new pilums, with the three pins! 8)
Not sure if the is enough room between the original 2 holes to make a third one, without weakening the wood? The holes as is need modification, being different sizes to accomodate the pin setup from the removeable ones, and as I don't have a bench with a vise, I am a little worried about making a botchjob if I were to try to drill another one...... :? roll:
Mind you, I could be less of a prima-donna, and go for it!! :lol: :lol:
But it would look good, I have seen Armillums new pilums, with the three pins! 8)
Visne partem mei capere? Comminus agamus! * Me semper rogo, Quid faceret Iulius Caesar? * Confidence is a good thing! Overconfidence is too much of a good thing.
[b]Legio XIIII GMV. (Q. Magivs)RMRS Remember Atuatuca! Vengence will be ours!
Titus Flavius Germanus
Batavian Coh I
Byron Angel
[b]Legio XIIII GMV. (Q. Magivs)RMRS Remember Atuatuca! Vengence will be ours!
Titus Flavius Germanus
Batavian Coh I
Byron Angel